COMPUSHIFT Main Connector Terminals and Seals
Overview
Generally, the harnesses provided by HGM have a full compliment of terminals and wires for the functions of that harness. Replacement parts should not be necessary in most cases, but are included below as a reference.
Manufacturer | Part Number | Description | Notes |
|---|---|---|---|
Molex | 34566-0703 | 2.54mm Pitch, MX123™ Female Receptacle Housing | Main connector on the harness |
Molex | 33468-0004 | 2.54mm Pitch MX64 Terminal | Terminals on each wire |
Molex | 34586-0001 | 2.54mm Pitch MX64 Cavity Plug | Plugs for unused locations on the harness connector. |
The design of the connector requires a wire and terminal or a cavity plug in order for the design to remain water tight. Failure to do so may flood the connector and will void any warranty by HGM.
Pinouts and Wiring Diagrams
The pinout reference for the main connector can be found here: COMPUSHIFT Main Connector Pinout
Most wiring diagrams for harnesses can be found here: COMPUSHIFT Sport and COMPUSHIFT Pro Wiring Harness Diagrams Note that some special OEM harnesses are not published on that page.
Contact HGM for further details, if necessary.
Inserting and Removing Terminals
We recommend reading the full reference from Molex available here: 34566-001-appl-spec.pdf.
When inserting the terminals, you should hear or feel a slight click when the terminal fully seats.
Terminal removal tools are available from HGM at a relatively low cost.