Final Checks

At this point, all of your wiring harnesses should be attached and in place, and the COMPUSHIFT II controller should be connected and mounted.

As a precaution, recheck all electrical connections and wire routing for safety.   If these are confirmed to be OK, then reconnect your battery.

Once the battery is connected, do the following:

  • Turn on the ignition switch to the first position, but do not start the engine.
  • Confirm that the status LED on your COMPUSHIFT II Controller is blinking red.
  • The display should be active and showing the Mixed Meter Screen.
  • Don’t drive yet… you still need to calibrate the throttle position sensor.