Skip to main content
Skip table of contents

Checkout and Testing

Final Checks

At this point, all of your wiring harnesses should be attached and in place, and the COMPUSHIFT II controller should be connected and mounted.

As a precaution, recheck all electrical connections and wire routing for safety.   If these are confirmed to be OK, then reconnect your battery.

Once the battery is connected, do the following:

  • Turn on the ignition switch to the first position, but do not start the engine.
  • Confirm that the status LED on your COMPUSHIFT II Controller is blinking red.
  • The display should be active and showing the Mixed Meter Screen.
  • Don't drive yet... you still need to calibrate the throttle position sensor.

 

 

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.