Skip to main content
Skip table of contents

Monitoring & Tuning Your System

The Display operates in two different modes – DASHBOARD and SETUP – and each offers a sequence of screens with useful information:

  • DASHBOARD screens are available while driving and display information about your transmission, COMPUSHIFT II and vehicle. The system displays information either in US standard or metric units, and you can select which you prefer in SETUP mode. The next section explains the Display DASHBOARD Screens.
  • SETUP screens are available when your vehicle is stopped and the engine is off with ignition switch on. SETUP allows you to change the Controller's programming. When COMPUSHIFT II is in SETUP mode, control of the transmission is disabled. SETUP is covered further in Display SETUP Screens.

Never try to enter SETUP mode while driving.


The buttons functions are standard throughout the screens: 

Up / Down ArrowsIncrease / Decrease Value
Right / Left ArrowsNext / Previous Screen
CenterSelect / Save
Top LeftOption
Bottom LeftExit / Go Higher in the Menu
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.