Here are the Acculink Installations for Barry Grant Six Shooter®
-
Follow all the normal instructions for the Acculink throttle position sensor.
-
Install Acculink on the center carburetor only.
-
Remove the connecting rod from the front to rear carburetor and install spacers using longer bolts provided.
-
Re-use the original locking nuts.
-
Check linkage clearance at all throttle positions.
-
Install pins in ratio arm using Loctite®
-
Adjust the Acculink TPS so there is no play in the adjustable link rod. The TPS must have some preload.
-
Check the full stroke so to ensure the TPS does not mechanically hit the end of travel. This can damage the sensor and make the COMPUSHIFT fail.
-
The ratio arm has a long end and a short end. This will allow you to adjust a stroke that will not damage the sensor.
-
The long end UP makes the stroke shorter and the short end UP makes the stroke longer. This moves the pivot point closer and farther from throttle shaft center.
-