Connecting a COMPUSHIFT to a Lokar Electronic Sport Mode Shifter
This article describes how to connect your COMPUSHIFT Sport or COMPUSHIFT Pro controller to a Lokar Electronic Sport Mode Shifter.
There are three switches on the Lokar Electronic Sport Mode Shifter. Each switch has three wires: a common (black), a normally open (blue), and normally closed (red).
The COMPUSHIFT Pro/Sport Paddle Shifter Harness has four wires: common (white), upshift (white/red), downshift(white/black), and mode (white/green).
Connect them according to the table below:
From | Wire | To | Wire |
|---|---|---|---|
Lokar Shifter Upshift Switch | Black | Paddle Shifter Harness Common | White |
Lokar Shifter Upshift Switch | Blue | Paddle Shifter Harness Upshift | White/Red |
Lokar Shifter Upshift Switch | Red | No connection (cut or tape off) | |
Lokar Shifter Downshift Switch | Black | Paddle Shifter Harness Common | White |
Lokar Shifter Downshift Switch | Blue | Paddle Shifter Harness Downshift | White/Black |
Lokar Shifter Downshift Switch | Red | No connection (cut or tape off) | |
Lokar Shifter Sport Mode On-Off Switch | Black | Paddle Shifter Harness Common | White |
Lokar Shifter Sport Mode On-Off Switch | Red | Paddle Shifter Harness Mode | White/Green |
Lokar Shifter Sport Mode On-Off Switch | Blue | No connection (cut or tape off) |
Full installation instructions on the Lokar Shifter can be found on the Lokar website.
Note that the mode switch on the Lokar Shifter is often adjusted incorrectly from the factory. You may need to adjust the position of the switch so that it is fully closed when the shift lever is in the left (automatic) position.