Skip to main content
Skip table of contents

System Units

Your COMPUSHIFT II can display units in either metric or US standards.

The default is US.  In metric mode, the measurements change as follows:

  • Speed is measured in KPH instead of MPH.
  • Temperature is measured in degrees C instead of degrees F.
  • Vehicle mass is entered in KG instead of LBS.
  • Pressure is measured in kPA or BAR instead of PSI.
    System Units      
  
         US

 

 

You can switch between measurement systems without affecting other programming. COMPUSHIFT uses metric units internally.

 

 

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close