Overview
Generally, the harnesses provided by HGM have a full compliment of terminals and wires for the functions of that harness. Replacement parts should not be necessary in most cases, but are included below as a reference.
|
Manufacturer |
Part Number |
Description |
Notes |
|---|---|---|---|
|
Molex |
34566-0703 |
2.54mm Pitch, MX123™ Female Receptacle Housing
|
Main connector on the harness |
|
Molex |
33468-0004 |
2.54mm Pitch MX64 Terminal |
Terminals on each wire |
|
Molex |
34586-0001 |
2.54mm Pitch MX64 Cavity Plug |
Plugs for unused locations on the harness connector. |
The design of the connector requires a wire and terminal or a cavity plug in order for the design to remain water tight. Failure to do so may flood the connector and will void any warranty by HGM.
Pinouts and Wiring Diagrams
-
The pinout reference for the main connector can be found here: COMPUSHIFT Main Connector Pinout
-
Most wiring diagrams for harnesses can be found here: COMPUSHIFT Sport and COMPUSHIFT Pro Wiring Harness Diagrams Note that some special OEM harnesses are not published on that page.
-
Contact HGM for further details, if necessary.
Inserting and Removing Terminals
-
We recommend reading the full reference from Molex available here: 34566-001-appl-spec.pdf.
-
When inserting the terminals, you should hear or feel a slight click when the terminal fully seats.
-
Terminal removal tools are available from HGM at a relatively low cost.