Installing Harness 50131 for a GM 24229422 Lever Position Switch

Overview

Harness 50131 connects a GM 24229422 Park Neutral Position Switch to your COMPUSHIFT Sport or COMPUSHIFT Pro. With it, the COMPUSHIFT can read every shift lever position on GM 4L60E and GM 4L80E transmissions.

Without this switch, these transmissions rely on the internal pressure switch manifold. That manifold only works while the engine is running. It cannot tell Park from Neutral, and it reads 2nd gear with the engine off.

The GM 24229422 switch is also known as the Manual Lever Position Switch (MLPS). It mounts on the manual lever shaft of later model 4L60E and 4L80E transmissions that have the mounting bosses and a long shaft.

What You Need

  • Harness 50131 (this harness)

  • GM 24229422 Park Neutral Position Switch

  • A ground connection for the switch. HGM part 50132, Neutral Safety Plug Kit for GM 24229422, provides this.

About the Switch Connectors

The switch has two connectors:

  • 4 way connector: carries the lever position signals. Harness 50131 plugs in here.

  • 7 way connector: carries the neutral safety and reverse light circuits, and the ground for the lever position signals.

The 7 way connector must provide ground. Terminal D on the 7 way connector is the ground for the lever position signals. If it is not grounded, the COMPUSHIFT cannot decode the selector position.

The 50132 plug kit is a mating connector for the 7 way connector. It has flying leads for the neutral safety and reverse light circuits. It also has a ring terminal for the ground, which attaches to a mounting bolt of the selector switch.

Installing the Harness

Harness 50131 has a 4 way Metri-Pack plug on one end and four flying leads on the other. The flying leads have terminals that go into the COMPUSHIFT main connector.

Before you start, read COMPUSHIFT Main Connector Terminals and Seals for how to insert terminals. Each cavity in the main connector must hold either a wire or a cavity plug to stay water tight.

  1. Insert each flying lead into the COMPUSHIFT main connector as shown in the table below.

  2. Plug the 4 way connector into the 4 way connector on the switch.

  3. Connect the 7 way connector on the switch, making sure terminal D is grounded.

4 Way Metri-Pack Terminal

Wire Color

COMPUSHIFT Pin

COMPUSHIFT Function

A

Black/White

50

Shift Selector 4

B

Light Blue

31

Shift Selector 6

C

White/Black

11

Shift Selector 7

D

Yellow

10

Shift Selector 5

For the full main connector pinout, see COMPUSHIFT Main Connector Pinout.

Setting up the COMPUSHIFT

After the harness is installed, tell the COMPUSHIFT to read the switch instead of the internal pressure switch manifold. In the CS Setup App:

  1. In Vehicle Setup / Set Transmission/Engine Type, choose your GM 4L60E variant or the GM 4L80E.

  2. In Vehicle Setup / Transmission Options / Shift Selector Sensor, choose GM 24229422 Lever Position Sensor.

  3. Restart the COMPUSHIFT when the app advises it. The setting takes effect at the restart.

  4. Check Diagnostics / Transmission / Shift Selector Position while moving the lever through every position. It should follow the lever, including Park, with the engine off.

  5. If you use CAN bus messaging over J1939, enable Send ETC2 in Network Setup / J1939 Messages and restart the COMPUSHIFT. The shift selector position and the range are sent in ETC2; see HGM CAN Bus Messaging for how they are represented.

  6. Requested Range and Selected Range make useful gauges. Requested Range shows the shift selector position; Selected Range shows the range the COMPUSHIFT is using. Add them to the Dashboard in the CS Setup App.